The number of mounting systems you have received depends on the shelf size you have ordered.

Download the Blob Shelf manual as a PDF

Download the template for the drill holes as a PDF


1. Collect the following tools: Hammer, Level, Drill, Torx screwdriver (T25) and wall plugs (M8) (depending on the material of your wall.


2. Check that every part of the Blob Shelf you ordered is in your package. The amount of mounting systems depends on the size of the Blob Shelf you have ordered.


3. Find templates per shelf size as to where to place the drill holes on the last page of this manual. Cut the right template out with scissors and stick them together with tape.


4. Tape the template to the wall and drill the holes that are indicated in the wall. Then carefully pull the template off the wall. Push a wall plug in each hole - the type of plug best to use depends on your wall.


5. Now screw part (A) of the mounting system into the wall with a Torx screwdriver (T25). Then screw part (B) of the mounting system onto the part (A) by hand.


6. Now carefully slide the shelf on the shelf supports. Use a wrench to make sure the mounting system clamps properly, and use a Level to make sure the shelf is horizontal.